Ventrac KX523, Руководство оператора

Страница: 14 / 49

SAFETY
Safety - 14
• This snow blower is capable of amputating hands and feet and throwing objects. Failure to observe the
following safety instructions could result in serious injury.
• Read and understand the KX523 snow blower operator’s manual before operating the snow blower.
• Before making repairs or adjustments to the snow blower, engage the power unit’s parking brake, lower
the snow blower to the ground, shut off the power unit’s engine, and remove the ignition key.
• Always block up the snow blower securely when adjusting the skid shoes.
• The snow blower housing is open in the front due to its functionality, thus exposing the auger. When oper-
ating, EXTREME care should be used when approaching a stationary object such as a tree or a pole.
• Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.
• Never direct the snow blower discharge chute in the direction of people, buildings, animals, vehicles, or
other objects of value. Debris can be thrown from the chute causing damage, serious injury, or death.
• Never operate the snow blower when people are in the area. Frozen snow, ice, gravel, and other
objects can be thrown at lethal velocity.
• Operators should be familiar with the area they are clearing and make preparations ahead of time.
Place guide stakes appropriately and remove stones, markers, or other debris that may be hidden after
a snowfall. Curbs, offsets, steps, man hole covers, broken or raised pavement, etc. should be noted.
Operators should map areas to be cleared before the winter season so they can review potential haz-
ards prior to clearing snow in the area.
• If an area is to be cleared that is unfamiliar to the operator, travel slowly and use EXTREME CAUTION.
Inquire of anyone who might know of potential hazards.
• Discharge snow with the wind direction as much as possible. Discharging into the wind reduces blowing
distance and visibility.
• The operator should never proceed if visibility is poor. If the tractor is equipped with a cab, the wind-
shield must be kept clean.
• Use caution when operating around objects that can obstruct your vision.
• Never travel at speeds that would cause injury to the operator or damage to the machine if the machine
were to be stopped suddenly by an unseen, immovable object.
• Never operate at high transport speeds on slippery surfaces.
• No one other than the operator should ever attempt to clear the discharge opening in the event of a
blockage. Lower the snow blower to the ground, set the power unit’s parking brake, shut off the power
unit’s engine, and remove the ignition key before any attempt is made to clear the blockage.
• Hand contact with the rotating fan inside the discharge chute is the most common cause of injury
associated with snow blowers. Never use your hand to clean out the discharge chute. Use the provided
chute cleaning tool to clear blockages.
• If the chute guard has been opened to clear a blockage, it must be closed and fastened before resum-
ing operation.
• Do not operate the equipment without wearing adequate winter garments. Avoid loose fitting clothing
that can get caught in moving parts. Wear footwear that will improve footing on slippery surfaces.
• Shut off the power unit’s PTO when not blowing snow.
• Always shut off the power unit’s PTO and engage the parking brake before dismounting to change the
angle of the discharge chute deflector.
• Attachment hydraulic system may contain stored energy. Before performing maintenance or repairs on
the hydraulic system, the attachment’s auxiliary hydraulic hoses must be disconnected from the power
unit. Lower the attachment to the ground, shut off power unit engine, move the secondary S.D.L.A. lever
left and right to relieve auxiliary hydraulic pressure, and disconnect the auxiliary hydraulic quick couplers.
KX523 Snow Blower Safety Procedures