Operation - 14
EDGER SETUP & CONFIGURATION
Edger Configurations
This section of the manual will explain various edger
configurations and how to properly set up these
configurations.
CAUTION
The disc edge may be sharp. Wear gloves when
handling the edger disc.
Normal Edging Setup (Disc Concave
Facing Toward Frame)
For normal edging operation, the disc is mounted
with the concave facing in toward the edger frame.
This is the standard factory setup of the edger.
For normal edging setup, the disc and disc mount-
ing components must be installed as shown below.
1. Disc Sprocket
2. Disc
3. Disc Washer
4. Washer
5. Bolt
3
2
1
5
4
3
4
5
1
2
Bed Shaping Setup (Disc Concave Fac-
ing Away From Frame)
When using the edger for bed shaping, the disc is
mounted with the concave facing away from the
edger frame. This setup is used for maintaining the
edges around flower and mulch beds.
It is recommended when setting up the edger for
bed shaping, that the disc assembly is rotated
so the disc is on the back side of the main frame
receiver tube. To set up edger for bed shaping:
1. Remove the 5/8” bolt (Ref. 5) and the1-7/8”
washer (Ref. 4) from the end of the shaft.
2. Remove the disc washer (Ref. 3), the disc (Ref. 2),
and the disc sprocket (Ref. 1) from the shaft.
3. Refer to the Disc Position Setup section for
instructions on rotating the disc mount frame to the
back side of the main frame receiver tube.
4. Position the disc washer (Ref. 3 and the disc
with the concave turned out away from the
edger and install onto the shaft.
5.
1. Disc Sprocket
2. Disc
3. Disc Washer
4. Washer
5. Bolt
3
2
1
5
4
3
4
5
1
2
Install the disc sprocket (Ref. 1) onto the shaft
and secure with the 1-7/8” washer (Ref. 4) and
the 5/8” bolt (Ref. 5).
