Ventrac Collection Vacuum RV600, Руководство оператора и чертежи запасных частей

Страница: 16 / 73

GENERAL OPERATION
Operation - 16
Daily Inspection
1.
Always set the parking brake, shut off the tractor
and collection system engines, remove the tractor
and collection system ignition keys, and ensure
all moving parts have stopped before inspecting,
adjusting, or servicing any component or function
of the tractor, mower deck, or collection system.
Park the tractor and collection system on a level
surface, with the engines shut off and all fluids cold.
2. Perform a visual inspection of the tractor and collec-
tion system. Ensure the collection system is properly
attached to the tractor. Look for loose or missing
hardware, damaged components, or signs of wear.
Inspect hydraulic hoses, hydraulic fittings, and fuel
lines to ensure tight, leak free connections.
3. Check the collection system’s engine oil and fuel
levels. Add or service as required.
4. Refer to the tractor operator’s manual. Check the
tractor’s engine oil, hydraulic oil, cooling system, tire
pressure, and fuel level. Add fluid or service system
as required.
5. If a mower deck will be used, inspect the mower
deck, drive belts, and mower blades. Belts should
be in good condition. Mower blades should be sharp
and securely fastened. Service as required.
6. Test the collection system’s operator safety interlock
system. Refer to Safety Interlock System in the
safety section of this manual.
7. Test the tractor’s operator safety interlock system.
Refer to Operator Interlock System in the safety
section of the tractor manual.
Attaching - Pin Connect Hitch System
1. Back the tractor hitch (A) into the collection
system hitch (B).
A A
B B
C C
If the collection system is not at
the correct height, turn the handles of the caster
wheel stands (C) to raise or lower the collection
system to the correct height. (NOTE: The terrain,
tractor tire pressure, and attachment on the front
of the tractor can affect the height of the tractor
hitch.)
2. Install the pin (D) to couple the tractor hitch to
the collection system hitch.
On tractors equipped with standard hitch, install
pin in location Y.
On tractors equipped with 3 point hitch, install
pin in location Z.
3.
Z Z
Y Y
D D
Engage the roll bar latches (E) to the roll bar
mounts (F) and install the retainer pins (G).
4.
E E
F F
G G
Connect the left set of hydraulic hoses to the left
hydraulic couplers of the tractor. Match the red
and yellow indicators on the hose ends to the
corresponding indicators on the quick couplers.
5. Connect the right set of hydraulic hoses to the
right hydraulic couplers of the tractor. Match the
red and yellow indicators on the hose ends to the
corresponding indicators on the quick couplers.