Vento URAGANO, Сборка и инструкция по установке, Страница: 7 / 8

Canopy
Downrod Set
Decorative Cover
Screw
Lock pin
- 5 - - 8 -
R Pin
VENTO
IV. INSTALLATION INSTRUCTIONS FOR CEILING
FAN REMOTE CONTROL
A. IMPORTANT POINTS:
B. OPERATION INSTRUCTIONS:
C. FUNCTIONS OF TRANSMITTER:
1.
2.
3.
4.
5.
6.
7.
8.
Please read this manual and keep it for future use.
Turn off the electrical mains at the circuit breaker/fuse box.
Please note that all wiring connections should be done by a qualified electrician.
This unit is to be used in an AC220V~240V / 50Hz, 60Hz supply zone only.
Do not install in damp locations or immerse in water. (For indoor use only.)
To avoid damaging the transmitter prevents dropping or banging the transmitter.
Do not attempt to shorten the receiver’s antenna wire.
If the transmitter is not used for some time, please remove batteries to avoid leakage
that will damage the transmitter.
1.
2.
After installing the receiver, make sure the transmitter has its batteries installed.
If the transmitter is not functioning properly or not function or if the fan is not moving
please do the followings:
a) Turn off the electrical mains at the circuit breaker/fuse box.
b) Follow steps on page 9-10 to reinstall the receiver.
HI
MED
LOW
OFF
Set fan to high speed.
Set fan to medium speed.
Set fan to low speed.
Turn off the ceiling fan.
:
:
:
:
NOTE: THE TRANSMITTER IS DESIGNED FOR USE WITH EITHER WALL BRACKET
FOR TRANSMITTER (d.) OR THE TRANSMITTER COVER (b.)
LOW
OFF HI
MED
Put the transmitter into transmitter cover.
Wall bracket for transmitter
(If desired, install onto the wall with screws.)
LOW
OFF HI
MED
a.) When mounting the fan, ensure that the safety wire is looped across the mounting
bracket .
b.) Tighten the two downrod set screws to make sure the fan run stably. Then, install
downrod (ball part) into
mounting bracket opening that already securely fastened
to a structural ceiling member. The tab opposite of the mounting bracket opening
should fit in slot on ball.
7.
Loosen 2 screws at the yoke of the motor assembly. Slide the canopy into the downrod.
Thread the power leads from the fan through the canopy, decorative cover and downrod
(take extra care not to pull power wires damage). Set downrod into yoke and rotate
until the holes match. Then, insert lock pin through the holes and firm it with R pin.
Tighten 2 screws and nuts at the top yoke of the motor assembly.
ATTENTION: Make sure the R pin and lock pin is proper and secure to prevent the fan
from falling or causing property damages or personal injury.
6.