Vento URAGANO, Сборка и инструкция по установке, Страница: 3 / 8

- 12 -
Installation must be carried out by a qualified electrician.
Turn off the electrical mains at the circuit breaker/fuse box.
Do not use power supply other than 220V~240V / 50Hz, 60Hz.
This appliance must be earthed.
When mounting the fan, ensure that the safety wire is looped across the mounting
bracket .
The mounting bracket must be able to withhold a min. weight of 35 pounds.
The ceiling fan must be mounted at a min. height of 7.5 feet / 2.3m of clearance from
the floor.
Do not place any objects in the path of the blades.
When all electrical connections are done, store all wires neatly.
Make sure that all screws and connections are tightly screwed and secured.
Note
This illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without prior notice for further improvements.
Warning
This product is designed to use only those parts supplied with this product and/or accessories
designated specifically for using with this product. Using parts and/or accessories not designated
for using with this product could result in personal injury or property damage.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
I. IMPORTANT SAFETY INSTRUCTIONS
- 1 -
Numbered tape placement Switch 1-2 Switch 3-4
Switch 4-2 Switch 3-1
5
1
3
4
2
5
1
3
4
2
5
1
3
4
2
5
1
3
4
2
5
1
3
4
2
PROBLEM A: FAN WILL NOT START
REMEDIES:
1.
2.
3.
4.
Check fuse or circuit breaker and replace if necessary.
Check that reversible switch is at exact position.
Turn off electrical power, check all wire connections.
Check to make sure the dip switches from the transmitter and receiver are set on the same frequency.
PROBLEM B: FAN EXCESSIVELY NOISY
REMEDIES:
1.
2.
Check that all screws in fan assembly are tight and properly seated.
Check to make sure mounting bracket is installed properly.
PROBLEM C: FAN WOBBLES
REMEDIES:
1.
2.
3.
Check that all blades are screwed firmly into the fan body.
If the above mentioned remedies can’t eliminate the wobble, use the clip from balance pack to
make sure the position. Stick the balancing weight on the opposite side of the mark place.
If the above mentioned remedies can’t eliminate the wobble, interchange the blade pair, proceeding
as following illustrations until wobble is removed.
VIII. TROUBLE SHOOTING