ATTENTION!
The appliance must be installed on a solid surface like concrete, wood or
metal etc.
Important:
Ensure that the supply cables are well mounted and that they do not come into
contact with the reflector of the heater or that it does not trail into heated areas. The supply
cable can be fixed to the metal mounting bracket behind the heater with plastic zip ties.
1. This heater should be installed by a qualified electrician.
2. Always disconnected the heater from the electricity supply and allow it to cool
before installation.
3. For ceiling mounting, the lowest part of the heater must be located at or above a
minimum height of 1.8m from ground level, so that the heater cannot be touched
when in operation.
4. For ceiling mounting, there must be a 1.8m distance from your appliance to the
ground.
5. When installed to the ceiling, there must be a distance of 0.5m between corners and
the appliance.
6. The distance of your appliance from any objects or persons is to be min 1m.
7. The distance from the front side of the heater to materials such as wood, cloth etc.,
must be min 1m.
8. When mounting to a ceiling, do not position the heater at an angle more than 90
degrees.
9. The supply cable must be at the lower end of the heater if it is installed at an angle
or vertically.
10. Keep the supply cord away from the body of the heater as it will get hot during use.
11. Do not install the heater on a flammable surface.
12. Observe the minimum safe distance between the heater body and the flammable
surfaces when mounted.
13. The heater should always have a minimum clearance of 0.5m from a ceiling and
adjacent wall.
14. If the heater is to be used outside, a weatherproof outlet is recommended.
15. Before drilling ensure that there are no wires or water pipes in the area where the
heater is to be installed.
16. The heater must be installed on the mounting brackets provided.
17. Fasten the brackets securely to the mounting surface and the backside of the heater
using the nuts and screws supplied.
18. Fasten the heater securely on the brackets using the nuts and bolts supplied.
19. The brackets can be used to adjust the direction of the heater, adjust the heater
angle by loosening the two bolts on the wall mounting bracket, and tighten the bolts
again when the desired angle is reached.
20. For bathrooms installation/s - the heater is to be installed so that switches and other
controls cannot be touched by a person in the bath or shower.
