INSTALLATION
WALL INSTALLATION
CEILING INSTALLATION
WARNING:
For your safety, all electrical work must be carried out by a licensed electrician.
WARNING:
Ensure the power supply to the exhaust fan is switched OFF before carrying out
any installation and maintenance.
NOTE:
A double pole disconnection mechanism must be incorporated in the fixed wiring
of the exhaust fan.
1.
Find a suitable location and cut the appropriate size hole for the unit. Ensure there are
no cables or pipes behind the wall when cutting. The hole should slope slightly to the
external wall, this will allow drainage of any ingress from rain.
2. Remove the front panel of the exhaust fan and position against the wall, and mark the
four fixing screw points and cable entry, and then drill to suit.
3. Place the exhaust fan through the cut out hole and position in place.
4. Connect the Live and Neutral supply wiring to the terminal block, replace the terminal
block cover and secure with screws.
5. Secure the fan to the wall via the four screws and mounting holes.
6. Replace the front panel and external shutter (External shutter not supplied).
1.
Find a suitable location and cut the appropriate size diameter. Ensure there are no
cables or pipes above the ceiling when cutting.
2. Remove the front panel of the exhaust fan and position against the ceiling mounting
surface and mark the four fixing screw points and cable entry, then drill to suit.
3. Place the exhaust fan through the cut out hole and position the exhaust fan in place.
4. Connect the Live and Neutral supply wiring to the terminal block, replace the terminal
block cover and secure with screws.
5. Secure the fan to the wall via the four screws and mounting holes.
6. Replace the front panel.
NOTE:
Where ducting (not included) is used, ensure the outlet ducted is such that to
avoid the back-flow of gases into the room from the open flue of gas or other
fuel burning appliances.
