2
READ INSTRUCTIONS IN CONJUNCTION WITH THE ILLUSTRATIONS
IMPORTANT
1. THE FAN MUST BE SITED AND CONNECTED IN ACCORDANCE WITH CURRENT IEE REGULATIONS
(UK) OR THE APPROPRIATE STANDARDS IN YOUR COUNTRY.
2. THIS APPLIANCE IS NOT SUITABLE FOR INSTALLATION IN A SHOWER CUBICLE OR ENCLOSURE
AND MUST BE SITED AWAY FROM ANY SOURCE OF WATER SPRAY, AND MUST BE OUT OF
REACH OF A PERSON USING A FIXED BATH OR SHOWER.
3. SITE AWAY FROM DIRECT SOURCES OF HEAT IN EXCESS OF 50ºC OR LESS THAN –10ºC.
4. WHEN THE FAN IS INSTALLED IN A ROOM CONTAINING A FUEL BURNING APPLIANCE, THE
INSTALLER MUST ENSURE THAT AIR REPLACEMENT IS ADEQUATE FOR BOTH THE FAN AND THE
FUEL BURNING APPLIANCE.
5. IF THE FAN CAN BE USED TO SUPPLY AIR INTO THE ROOM THE INSTALLER MUST ENSURE THAT
THE FAN INTAKE IS LOCATED AT LEAST 600mm AWAY FROM ANY FLUE OUTLET.
6. IT IS RECOMMENDED THAT THE CONNECTION TO THE CONNECTOR SOCKET BE MADE WITH
FLEXIBLE CABLE FOR EASY MAINTENANCE.
7. WIRING SHOULD BE VIA A SWITCHED SPUR WITH A 3 AMP FUSE (UK ONLY).
8. DOUBLE POLE SWITCH WITH A MINIMUM CONTACT SEPARATION OF 3MM OR PLUG AND SOCKET
SHOULD BE LOCATED OUTSIDE THE ROOM CONTAINING A FIXED BATH OR SHOWER.
9. THIS
APPLIANCE
MUST BE EARTHED.
10. READ THESE INSTRUCTIONS FULLY BEFORE COMMENCING INSTALLATION.
11. THE APPLIANCE IS NOT INTENDED FOR USE BY YOUNG CHILDREN OR INFIRM PERSONS
WITHOUT SUPERVISION.
12. YOUNG CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE
APPLIANCE.
INDOOR FRAME
SHUTTERS
INDOOR GRILLE
HOUSING
CONNECTOR SOCKET
SHUTTER
ACTUATOR
IMPELLER
BASE
MOTOR BODY
HOUSING
POWER SUPPLY/
RECEIVER UNIT
SPEED CONTROLLER
CONNECTION SOCKET
(WIRED VERSION ONLY)
WALL LINERS
OUTDOOR GRILLE
OUTDOOR FRAME
Fig. 1.
