8) Remove screws and Heat
Exchanger Retaining Clamp kit Fig 10.
(Discard polybag)
9) Insert Heat Exchanger through
Chassis and into Wall pipe Fig 11.
Note: Line up key on top of Heat Exchanger
with slot in Chassis
10) Fit Heat Exchanger Retaining
Clamp with the screws provided Fig 12.
11) Close Door and
connect 24V Supply as described in
section B – Wiring, Adjust any settings
as required see section C – Setup. Fig 13
5
Fig.10
Fig.11
Fig.12
Fig.13
Connect to
Terminal block
Ensure cable
Clamp is used
SELV PSU
