Electric TV Lift, TS700A & TS1000A
8
Setting options for operation of lift
This remote system has 4 ‘jumpers’ inside the remote receiver box, these can be lifted and
positioned ‘Left’ or ‘Right’ depending of how the functionality of the lift should be.
Jumper A – Power safety cut off time
Default ‘Left’ = 60 seconds. If moved to right
position then the lift will power off
automatically after the motor has run for 20
seconds.
Jumper B – Remote emitter function
Default ‘Right’ = the buttons on the emitter
only need to be pushed once for activation. If
moved to the left position then the emitter
button will need to be held down during the
operation of the lift, ie..for use where a higher
level of safety may be required.
Jumper C – Auto-reverse time (type A lifts only)
Default ‘Right’ = a reverse period of 1 second. If moved to the left position, the reverse time
is reduced to 0.6 of a second.
Jumper D – Using the lift upside down (type A lifts only)
Default ‘Right’ = normal operation in an upright position ie.. to raise a TV up and down from a
floor standing cabinet. If moved to the left position the reverse function will work with the lift
mounted up-side down ie.. to lower down and up a TV from the bottom of a wall mounted. If
no reverse function is required then remove the jumper.
Change of battery in emitter (type 27A/12V)
o
remove lid on back side
o
lift up battery
o
place new battery
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions; 1) This device may not cause any harmful interference and 2) This device must
accept any interference received, including interference that may cause undesired operation.
