10
2.13 FUNCTION / MIX ( MIXING )
MIX - MIXING - used to mix between functions for greater control of the model.
1) Press
ENTER
to see the
FUNCTION MENU.
2) Use the
+/- KEYS
to highlight
MIX
and press
ENTER.
3) Press
ENTER
to select a setting.
4) Use the
+/- KEYS
to change the value.
5) Press
EXIT
to save and return to SYSTEM MENU, press
EXIT
to return to the
FUNCTION MENU, press
EXIT
again to Main Screen.
TERMS: EN-ENABLE, ST-STEERING, TH-THROTTLE, AUX-AUXILLIARY,
Throttle Hold allows the Throttle Servo to be set to a percentage of the total travel range.
This is an alternative to using the choke on a gas motor when starting up a model.
This function locks out the normal use of the Throttle until the
TH. HOLD
button on the
transmitter is pushed again. Make sure the value is only set high enough to idle the motor
during starting and warm up.
NOTE: Setting the Throttle Hold value too high may
cause a run away vehicle.
2.14 FUNCTION / TH. HOLD ( THROTTLE HOLD )
1) Press
ENTER
to see the
FUNCTION MENU.
2) Use the
+/- KEYS
to highlight
TH HOLD
and press
ENTER.
3) Press
ENTER
to select a setting.
4) Use the
+/- KEYS
to change the value.
5) Press
EXIT
to save and return to
SYSTEM MENU
, press
EXIT
to return to the
FUNCTION MENU
, press
EXIT
again to Main Screen.
To use this setting while running the model press
the
TH. HOLD
button located to the left side of
the throttle trigger once. Doing so will enable the
TH. HOLD
and put the throttle at the set value. To
release the
TH. HOLD
press it once more giving
full function to the
TH.TRIGGER
.
SERVO
LOCATED ON THE RIGHT
SIDE OF THE TRANSMITTER
