INSTALLATION NOTES
1
Cut the aperture to the dimensions shown in the table below or use the template provided
on the packaging.
2
Invert the hob and apply the sealing agent provided to match the outer perimeter edge.
3
If the sealing agent is a strip type, the protective covering must be removed from both
sides. Do not leave a gap in the sealing agent or overlap the thickness.
NOTE: do not use any Silicone based sealant, as this can damage the worktop surface if
repairs are required.
4
Insert the appliance into the aperture and fix into position via the clamps & screws,
tightening the screws evenly (see fig.3.)
Fig.3.
9
