Vendo VUE 30, Руководство пользователя

Страница: 122 / 125

T-11
04/2005
ERROR
PROBABLE CAUSE
CORRECTIVE
ACTION
Bill acceptor takes a bill but does not establish credit.
Defective acceptor harness (credit not getting from acceptor to control board through the harness).
Make sure that the acceptor and harnessing is correct for your style of acceptor and it is plugged in and wired properly
.
Defective acceptor
.
Replace/test acceptor
.
Defective controller
.
Replace/test controller
.
Bill acceptor takes a bill and credits but not erasing credit.
Defective bill acceptor
.
Replace acceptor and test acceptance and erasure of credit.
Defective controller
.
Replace/test controller for erasure of credit.
Both vend sensors are defective
Replace vend sensor
.
Acceptor takes a bill and allows payback of coins without a selection.
Controllers confi
gurations not set properly
.
Access vendor confi
guration mode and check the “Forced V
end” setting.
VENDING PROBLEMS Hand not in home postion
Communication error between VMC and PDC or PDC software error
Cycle power to unit. Start-up routine should begin.
Hopper is open
V
end optics blocked
Enter
T
est Mode check V
end Detection (see service manual). Cycle power
to unit. Strat-up routine should begin.Relpace/T
est vend optics.
No vend upon selection.
No power or communication to hand.
Check for lights on hand. Left side red light (motor power) right side fl
ashing (logicpower/ communication). If no light than check MDB
connection on VMC.
Hand not aligned correctly to tray when vending.
T
ray or shelf out of position (not seated).
T
ray table
in the PDC not present or correct.
Reseat tray or shelf. Run calibration #1 then #2.
X-rail not moving, product in hand.
V
end flap motor umpluged or linkage broken.
T
est vend flap in
T
est Mode. Replace if broken.
Completely sold out while product is still in the column.
Product pusher not functioning
Check to see if product pusher is engaged.
MISCELLANEOUS PROBLEMS Door will not close completely
.
Hand assembley hitting the lower blukhead.
T
ri-T
eq
lock system is in the locked position.
Reposition y-rail stops and check y-home magnet. Open
T
ri-T
eq lock,
check for damage to lock slide.
Display shows sold out immediately upon pressing selection button of full column (sold out not clearing).
Door switch wired incorrectly or cut/pinched.
Manually press door switch. If still not vending, check wiring or replace door switch.
Defective control board.
If door switch is replaced and still reading sold out, replace control board.
V
endor appears dead; no digital display and
no lights.
Defective main harness.
If red light on control board is of
f, check fuse and transformer
.
No digital display; vendor lights on.
Defective display or display harness.
Check display and display harness. Replace if necessary
.
Check for a flashing red light on control board.
If no light, replace control board.
V
endor scrolls message on display but does
not accept money
.
Changer out of tune.
See “T
uning Changer”.
Defective changer
.
Replace changer
.
Defective controller board.
Replace control board.
V
endor accepts money but does not display
credit.
Defective changer
.
Replace changer
.
Defective controller board.
Replace board.