Programming Manual
GLASSFRONT VENDING MACHINES
Rev. 1.12
MODELLS: G-DRINK SVE GF6 / GF9 – DR6 / DR9
Page 13 of 42
TEST VEND ROUTINE
If ENTER button is pressed at the "TEST" prompt the VMC will enter the test routine.
Upon entry into this routine the display will show the first test "SELE" the description of the
test routines available are the follows:
”SELE”
to test selection switch
“DRUM“
delivery drum test
“POWER”
Power on off time &date
"VEND"
Test vends
“FAIL”
Historical of jamming
” SELE”
Activation of the ENTER button (at the” SELE” routine) will show the last selection button
pressed “SEY” where Y is the number of the selection. Use this routine to test all the
selection switch. From software version 0.08 there is the possibility to test the delivery
eyelet switch, when you open the delivery flap the display show “DELIV”. To come back to
the “TEST” menu, keep pressed the first selection for two seconds.
“DRUM”
Drum test allows to test and drive separatefunctions
"LOCK"
Put the drum in lock postion
"UNLOCK"
Put the drum in unlock postion
"OPEN"
Put the drum in open postion
(Be careful to proceed the unlock position before using open and close test )
"CLOSE"
Put the drum in locked position
(Be careful to proceed the unlock position before using open and close test
“POWER” Show the power-on / off and date&time of the vendor
"VEND"
This parameter is used to set the number of test vends (1 to 255) to be performed
after the door is closed. Test vends are not recorded.
“FAIL”
Displays the historical data of the lift failures during vend process.
Press ENTER button to display the last 10 failures - Snn Hour / Minute/ Day
Press UP button to visualize the next failure
Press button 5 to clear all failures
(Failure clearing must be performed after installation of new software from version 1.35d)
Press escape button to come back to the “TEST” menu.
