Electrical connection
Display unit
PWR connector ( 6 pins )
This connector is for power supply and communication between main unit and display unit. Without this connector
connected, Dash7 won‘t work. This connector is wired from factory and this pinout is only for troubleshoting
purposes. Do not modify factory wiring harness! Modifying factory harness can cause damage of your Dash7 and will
void a factory warranty!
Power connector pinout:
Pin 1: to main unit connector pin A8
Pin 2: to main unit connector pin A2
Pin 3: to main unit connector pin B7
Pin 4: to main unit connector pin A7
Pin 5: to main unit connector pin A6
Pin 6: to main unit connector pin C7
CNTRL connector ( 7 pins)
This connector is used to control the main functions of display, switching screens, adjusting brightness, hide
warnings, change settings, etc... .
Without this connector connected, the Dash7 will work normally, but you will be unable to control it’s functions or
change settings.
Control buttons are packed in the box with your Dash7. Depends on your order specifications, you can buy separate
buttons, buttons on PCB or buttons in plastic case.
Control connector pinout and wiring diagram:
Pin 1: push button RIGHT (pink wire)
Pin 2: push button LEFT (blue wire)
Pin 3: push button UP (green wire)
Pin 4: push button DOWN (red wire)
Pin 5: push button OK/ENTER (violet wire)
Pin 6: Not In Use (yellow wire)
Pin 7: buttons supply GND - GROUND (white wire
+ black wire + shielding wire twisted together)
WARNING:
These wire colors are not guaranteed and may be changed at any time without notice!
NEVER APPLY ANY VOLTAGE TO THE CNTRL CONNECTOR! Otherwise, you can damage your Dash7!