- 28 -
User Manual
Athena
English
• When on the main page, it is possible to view more details about the current zone
using keys and . If key is pressed when on field 14 (see Figure 1), the
current zone name will appear (if it was entered; otherwise the reading “zona…” will
appear).
• To view the temperature measured by the external probe, press again from field 14
(If the probe exists and was previously configured).
• To view the minimum and maximum temperature measured by the external probe
in field 5, press again. To set these values to zero, hold the
key down for at
least three seconds.
• To return to the main page, press key again.
• To view the daily programming and the temperature in other zones, use arrow keys
and .
Note: zones that are not correctly configured are not displayed (cfr. “Advanced
programming” section).
MANUAL OPERATION
• This function is enabled/disabled by pressing key
• When in manual operation, the display reads the
symbol and the programmable thermostat works as an
ordinary thermostat, using the setpoint read on field 14.
• The control setpoint can be changed using keys
and . The setpoint may range from 2,0° to 35,0°.
The default setting is 18,0° for winter operation;
it is 23,0° for summer operation.
NOTE: the 4 zones can be switched to manual mode
with different individual setpoints.
EXTENSION PROGRAM
• The extension program enables the device to switch to manual mode for a certain
length of time (up to 96 hours).
• AAs soon as the extension program time expires the programmable thermostat
switches back to automatic.
• To enable the extension program, hold key down for at least 3s. The display will
read the symbol
, the word “extension” and the time (flashing).
• Set the time using arrow keys and and confirm by pressing the
[OK]
key.
• During the extension program it is possible to change the setpoint just like in manual
mode.
NOTE: to cancel the extension program just set the time to 00:00. The extension
program cannot be enabled if a countdown program is already enabled.
ESC
