Veloteq CF-2104, Руководство пользователя

Страница: 13 / 14

13
How to lubricate the running decking?

Find the silicone bottle. In the hardware bag come with the treadmill.

Find a straw can put into the silicone bottle, as picture show

Spray silicone evenly on treadmill deck as the drawing shows.
(ATTENTION: The treadmill MUSTBE STOPPED before applying
the silicone lubricant. This is to prevent injury, otherwise the edge
Of the running belt may cut you or your fingers could be crushed
by the rollers. ) Do not put too much silicone on the deck. Excessive
lubricant may cause slippage of the belt on the rollers.
5.3
、
Belt Adjustment
All running belts are properly set at the factory
，
if off-center occur, maybe caused by
followed reasons:

Treadmill is not stable;

User's feet are not in the center of the running belt;

User push off harder with one foot than with another.
If the off-center phenomenon caused by user, can return to normal after a few minutes
running with no loading, If the running belt remains consistently off-center, you will need to
center the running belt manually, If toward the left side of the deck, Using wrench, turn the
left adjustment bolt clockwise 1/2 turn and check ,if toward the right side, turn back a little,
till return to center. (As picture followed)
5.4
、
Running belt "Slipping"
You may need to adjust the running belt during the first few weeks of use... It may
stretch, appearance is normal when no loading, “slipping" or hesitating when runner plant
the foot during a run, when this phenomenon occur, turn both adjustment bolts clockwise
1/2 turn, make sure the turn of both sides is the same, and every time 1/2 turn, till no
"slipping" and no off-center, Be careful not to tighten the running belt tension too much as
you can create excessive pressure on the front and rear roller bearings. An excessively
tightened running belt may damage the roller bearings that would result in bearing noise
from the front and rear rollers.
5.5
、
Lubricate rollers
Regularly add drops of silicone to the rollers and shafts to keep the good performance.
5.6
、
Bolts fastening
Regularly check the bolts
、
screws and nuts, if any loose, please fasten immediately with
tools.