Veloteq Owner Manual 2008 P. 15 of 15 2/18/2008
Lube-injection Auto-geared Electric Motor Installation and Oil Maintenance
Gear oil Replacement
After the first 300km of use, subsequently replace the gear oil after every 3000km. Use approximately 150ML of No.26 Universal Gear
Oil, HQ-10 lubricating oil or SAE 10W/30 15W/40 Engine oil. With vehicle on the center stand, idle for three minutes to preheat the oil.
Turn off the ignition.
Unscrew gear case oiling screw and oil drain screw. Drain out the oil.
Replace the oil drain screw and screw tightly. Then fill the new oil from Gear Filler opening，about 100 ML.
Install and screw the fill bolt and drain bolt.
Motor Bushing Lubrication & Oil Fill Reservoir
(Apply grease to bushings.)
There are oil seals on both sides of the fork. Apply grease to the interface of oil seal and bushing. Avoid sand or dirt and listen for an
abnormal sound while filling, which will cause fraying of the oil seals.
