Veloteq Owner Manual 2008 P. 9 of 15 2/18/2008
The Cavalier RSV-GT (500!-GT), Challenger RSV-GT (500C-GT) , Commander SHO-GT (500D-GT) and
Commuter RSV-GT (500ZX-GT), Cougar XR8 (500XR) and Sorrento-GT (500B-GT) are equipped with
both a speedometer and an odometer.
Parking Your Electric Bicycle:
When parking, grasp the brake handle to steady the vehicle while alighting, turn off the ignition and
remove the key. Lower the kickstand and insure that the vehicle that the ebike is firmly in place.
Turn the front wheel to the right after parking. It is a good practice to park with the rear of the ebike
towards a wall or other structure with the front end facing out. Activate the anti-theft alarm system if
desired to discourage tampering with your vehicle or to use as a vehicle locater. Avoid riding or park-
ing on muddy or bumpy roads or surfaces as far as possible. Use the main center kickstand only
when necessary for service or parking on un-level surfaces. Do not, under any circumstances, sit on
the vehicle while it is elevated on the main kickstand. This can result in damage that may require re-
pair or replacement. All Veloteq electric bicycles have locking steering columns to hold your vehicle in
place after parking.
Circuit Breaker Location and Operation:
The electrical system is protected by a CCC Approved circuit breaker. An adverse load condition as a
result of current overload will cause the circuit breaker to trip, cutting power to the electrical system
until the adverse load condition has been corrected. This can be brought about by continuous opera-
tion on long inclines, particularly in hot weather. The circuit breaker is located inside the glove com-
partment of the 500A-GT, 500C-GT, 500XR and 500ZX-GT models. On the 500D-GT model, it is lo-
cated beneath a small access door behind the seat and on the 500B-GT, it is inside the underseat stor-
age compartment. After re-setting, if the circuit breaker continues to trip, bring your vehicle in for ser-
