Velodyne VI-Q, Руководство пользователя

Страница: 15 / 44

VI-Q MANUAL WWW.VELODYNEACOUSTICS.COM
ENGLISH
15
IN
OUT
L
L
HIGH LEVEL IN
DC OUTPUT 5V 1A
R
+
L
-
0°
180°
PHASE
MIN MAX
25Hz 200Hz
VOLUME
FREQUENCY
BALANCED
PWR
ON
12V TRIGGER IN
OFF DSP
ON
PAIRING
A
U
TO
OFF
R
R
OUT
STEREO
IN
L R
ON
OFF
110-120V, FUSE T6.3AL/250V
220-240V, FUSE T3.15AL/250V
110-120V~60Hz
220-240V~50Hz
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOC ÉLECTRIQUE
NE PAS OUVRIR
WARNING: SHOCK HAZARD - DO NOT OPEN
WARNUNG: STROMSCHLAGGEFAHR - NICHT ÖFFNEN
AVIS : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
CAUTION:
DISCONNECT POWER CORD BEFORE CHANGING FUSE.
REPLACE WITH SAME TYPE OF FUSE.
TRENNEN SIE DAS NETZKABEL, BEVOR SIE DIE SICHERUNG WECHSELN.
SICHERUNG DURCH GLEICHEN SICHERUNGSTYP ERSETZEN.
ATTENTION:
AVANT DE REMPLACER LE FUSIBLE, DÉBRANCHEZ LE CÂBLE
D'ALIMENTATION. REMPLACER PAR LE MÊME TYPE DE FUSIBLE.
ACHTUNG:
SERIES
+ -- + --
R L
Amplifier / Receiver
HIGH LEVEL CONNECTION
Older stereo amplifiers and even some current models
do not have an LFE jack or a line connector for RCA
plugs. But even these audio devices can be easily
connected to a Velodyne Acoustics woofer via speaker
terminals. The front speakers of the system are wired
in parallel with the amplifier and the subwoofer. With
this type of connection, the subwoofer‘s crossover
removes all high and mid frequencies and only bass is
reproduced. It is important that „Subwoofer Direct“ is
not used with this setting. Also, both channels should
be connected because they may contain different
bass information that would otherwise be lost during
playback.