VelLight LEDC16, Руководство пользователя

Страница: 4 / 23

LEDC16
V. 02 – 21/10/2015 4 ©Velleman nv
sure the power supply voltage is the same as the LED load and the power can handle the load
wattage.
2. LED Output
The controller supports constant voltage driving LED devices with common anode connection. The
black cable on the output side is the common anode and connects to the power supply positive
inside the controller. The green, red and blue cables run the driving signal of the relevant LED
colour. Connect the colour cables to the cathode of the relevant colour LED loads and the black
cable to the common anode.
The controller has an output with overload protection. If the controller stops working, please check
for short-circuit or an overload at the output.
3. Status Indicator
This is a full colour indicator that will display the controller’s working status as follows:
blue – fast flash starting up
blue/yellow – fast flash waiting for Bluetooth pairing
blue/yellow – short flash Bluetooth connected
blue – steady Bluetooth disconnected
white – single short flash new command
red – flash overload protection activated
yellow – flash overheat protection activated
7. Operation
Bluetooth Pairing
This unit will connect to your smartphone via Bluetooth. It must be paired to your smartphone before the
app will work.
When powering your controller it will enter the pairing mode for 90 seconds; the indicator will flash blue
and yellow quickly. Your smartphone will search for the Bluetooth device and find it as LED-XXX, the X
being the serial number of the controller. Select this device and your smartphone will connect to the LED
controller.
The Bluetooth device can only be found in these 90 seconds by an unpaired smartphone.
Bluetooth Reconnection
The Bluetooth connection of your smartphone to the controller can only be done manually. When
connection is lost or the controller has been powered off and on again, proceed as described in
Bluetooth Pairing to reconnect your controller.
Note: Use module F-1368 with QDID B020742.
8. Advanced Features
IP66 Waterproof
The controller is IP66 waterproof, i.e. it is dust-tight and protected against heavy water jets. However, to
ensure full working capacity and to avoid damage, do not immerse the controller in water.
Flicker-Free Operation
This controller works at 8 kHz and is fully flicker-free, even with fast and slow movie applications.
Although it absorbs most unwanted switching interference, avoid driving strong inductive effect loads for
better performance. Also, avoid twisting the output cables.
Protection
This controller is fully protected against short circuits, overloads, incorrect cable polarity and overheating.
The controller will recover automatically when working status is restored.
To avoid overheating, make sure the controller is used in a well-ventilated place.
9. Cleaning and Maintenance

This controller does not need any particular maintenance.

Occasionally wipe the controller with a damp cloth to keep it looking new. Do not use harsh
chemicals, cleaning solvents or strong detergents to clean the detector.