Velleman VTSS200, Руководство пользователя

Страница: 4 / 33

VTSS200
V. 02 – 14/04/2014 4 ©Velleman nv
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
•
Only use the device for its intended purpose. All other uses may lead to electric shocks, personal
injury, fire, etc. Using the device in an unauthorized way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
•
Keep this manual for future reference.
4. Features
•
auto cool-off process upon turning off the unit to ensure safety and to prolong heating element's life
•
adjustable airflow and temperature to suit your needs
•
energy efficiency: internal, conductive switch in the handle automatically starts the heating element
as soon as you take the handle in your hand; heating stops when you place the handle back in its
holder
•
compatible with various types of air nozzles
•
fast heat-up
•
can also be used as a hot air gun
5. Overview
Refer to the illustrations on page 2 of this manual.
1 nozzle 8 heating pipe
2 holder 9 protective ring
3 handle 10 holder bracket
4 display 11 fan
5 temperature control buttons 12 circuit board
6 airflow control knob 13 heating element
7 on/off switch 14 mica sheet
6. Installation
Before the first use, you have to install the holder [2] on the device. You can fit the holder on the left or
right side.
1. Align the screw holes in the holder bracket [10] with the pre-drilled screw holes on the desired side
of the device, and fix the holder using two screws.
2. Fix the holder [2] to the bracket using four screws.
3. Place the handle [3] in the holder and check if it fits safely.
7. Operation
The nozzle and the airflow reach very high temperatures while the device is in use. Be careful
to avoid burns.
Always place the handle back in the holder, do not place it on the table or any other surface.
Tip: To extend the life span of the heating element and to lower the risk of heat damage to ICs, work at
the lowest possible temperature and the highest airflow.
1. Fit an appropriate nozzle [1] to the heating pipe [8] and place the handle in the holder.
Caution: Always let the device cool down completely (± 30 minutes) before fitting a nozzle.
2. Connect the power cord to a suitable, earthed mains outlet and use the on/off switch [7] to switch
the device on.
The display shows "SLP". The device is now in standby mode.
3. Set the airflow [6] to the maximum position.
4. Set the required temperature using the temperature control buttons [5] . Press once to
increase/decrease the desired temperature by 1 °C. Press and hold to increase/decrease faster.
The display shows the set temperature during 2 seconds. After that, the displays shows the actual
temperature.
5. Take the handle in your hand: the unit now heats up to the set temperature. Wait a few seconds
until the temperature is stable.