VRC801D2
VELLEMAN
7
correctly. You can press any device key again (e.g. TV) to exit set-up or use UP or DOWN to
select another set-up.
Learning
The learning function is used to extend the pre-programmed code list. The default code list
may provide all required functions, but it is still possible to add a small number of additional
functions for your new remote control. Use the learn key to program commands or the Delete
key to delete programmed commands, or select DeleteDev to delete all the commands for a
single device, or Delete All to delete all the programmed commands of all the devices in the
learning class. Press the Learn key for more than 3 seconds to access the learn mode.
Programming a Command
1. Press the respective device key (e.g. TV) of the device which you wish to carry
out programming
2. Press he SET key for more than 3 seconds, then release it (or Press the Learn key for more
than 3 seconds to access the learn mode).
3. Press the UP and Down key to select Learning in the LCD menu, then press the OK key.
4. Press the UP or DOWN key to select Learn Key in the LCD menu and then press OK.
The Select key is displayed on the LCD screen. If you wish to exit the learning mode, please
Press the device key.
5. Select the (target) key which you wish to program (e.g. Power).Waiting is displayed on the
LCD screen..
6. Aim the IR window of the original remote control at the IR receiver window of your new
remote control (Distance approx. 50mm)
7. Press the original remote control key (e.g. Power) until Success is displayed. If failed is
displayed on the LCD screen, Repeat Steps 4-6.
8. Repeat Steps 4-6 to program other keys.
9. Press a device key (e.g. TV) to exit the learning operation once all the desired commands
have been programmed.
Remark:
1.
A programmed target key can programmed from various source keys more than once.
This remote control only Saves the most recently programmed signal.
