SO11001 (CARSFM2)
30/09/2009
6 ©
Velleman nv
•
Set the same frequency on the car radio, either manual or via the RDS auto
synchronization function. This function enables automatic synchronization of
the radio frequency with the transmitters’ frequency after the auto search
function.
Note: this feature only works when supported by the car radio!
Briefly press the MENU/REPEAT button 5 times. Use the
or
button to
select sync mode.
Music input
•
There are 3 ways to provide music files to the transmitter (see §7: file
organization):
1.
using an SD-card. Slide the SD-card in the SD-card slot [C] (pins facing
down).
2.
via a USB device. Connect the USB device to the USB connector [D].
3.
through the 2.5mm mini jack. Plug the 2.5mm plug into the mini jack [E].
•
Press and hold the MEM/SD-USB button for ±2s to switch between SD and
USB input.
Playback
•
Set the volume on the transmitter to an average level. Press the
MENU/REPEAT button twice followed by the
or
buttons (7 levels). Use
the volume control on the radio to get the best signal quality.
•
Press the button, to toggle between pause and play mode. In play mode,
press the
or
buttons
to skip to previous or next track. Press and hold
or
for ±2s to skip to previous or next folder (see §7: file organization).
•
In playback mode, press and hold the button for ±2s to switch the
transmitter display between frequency or remaining play time.
•
In playback mode, pressing and holding the MENU/REPEAT button for ±2s will
scroll through playback modes:
1x Shuffle
mode
2x Repeat
current
track
3x Repeat
current
directory
4x
Normal playback mode
•
7 frequencies can be stored for quick access. First select the desired
frequency, than press the MEM/SD-USB button. Use the
or
buttons to
select a memory address (1~7).
•
To recall a stored frequency, press the MEM/SD-USB button repeatedly until
the desired frequencies is shown on the display.
RDS
•
For music tracks that are provided through the USB-port and that contain an
ID3-tag, a car radio with RDS (Radio Data System) functionality will show the
track information on its display.
•
Briefly press the MENU/REPEAT button 3 times. Use the
or
button to
select the RDS display method and press the MENU/REPEAT button again.
NOR: display shows 8 characters
SCR: display scrolls with 1s interval
•
Briefly press the MENU/REPEAT button 4 times. Use the
or
button to
select the interval time under normal RDS display mode (2~6s) and press the
MENU/REPEAT button again.
