LEDA500xxW-x / LEDA5010NW-B
V. 03 – 25/01/2019
4
©Velleman nv
5.4
Mounting the lamp
1.
This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
2.
Use the mounting bracket to determine the location of the mounting holes.
3.
Drill the holes and secure the bracket using screws and wall plugs.
4.
Connect the power cable to the screw terminal. Make sure there is no strain on the cable; leave
sufficient slack.
N = neutral, blue
E = earth, yellow/green
L = line, brown
Warning
: if the power cable is damaged, it must be replaced by the manufacturer, his service agent, or
a similar qualified person in order to avoid any hazard.
5.
To point the lamp in the desired direction: loosen the hinges using a screwdriver.
6.
Tilt the lamp in the desired angle and tighten the hinges.
6.
Cleaning and Maintenance
This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
All screws should be tight and free of corrosion.
The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the connections…
The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
If the protective glass is damaged, disconnect the lamp immediately from the mains. Have it repaired
immediately by a qualified technician. Do not use the lamp with a cracked or broken protective glass.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
7.
Technical Specifications
LEDA5001NW-x
LEDA5001WW-x
body colour
black/white
electrical data
power LED module
10 W COB
total nominal power
10 W
nominal voltage driver
220-240 V~
power factor
0.57
energy consumption
10 kWh/1000 h
light technical data
colour
neutral white
warm white
colour temperature
4000 K
3000 K
beam angle
120°
