VDL3002MR VELLEMAN
1
VDL3002MR – MUSHROOM
1. Introduction
Thank you for buying the
VDL3002MR
! Please read the manual carefully before bringing this
device into service.
The
VDL3002MR
features two rotating lamps that create a fast-moving effect.
Make sure that the device was not damaged in transit. If the device is damaged, you should
contact your dealer and postpone installation of this device.
2. Safety Instructions
•
A qualified technician should install and service this device.
•
Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
•
Do not switch the device on immediately if it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
•
This device falls under protection class I. It is essential, therefore, that the device be earthed.
A qualified person must carry out the electric connection.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications
of this manual.
•
Do not crimp the power cord and protect it against damage from sharp edges. Ask an
authorised dealer to replace the cord if necessary.
•
There may be some smoke or a particular smell when the device is activated for the first
time. This is normal and any smoke or smell will gradually disappear.
•
Always disconnect the device from the mains when it is not in use or when you wish to clean
it. Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
•
Do not look directly into the light source as sensitive people may go into epileptic seizure if
they do.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
Keep the device away from children and unauthorised users.
Protect this device against rain and moisture
Unplug the supply cable before you open the housing
Be very careful when installing the device : touching
live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up
