CCTVPROM15
V. 1.0 – 07/12/2012
6
©Velleman nv
P.T.Z.
= SEQ +
Press SLOW and
simultaneous to enter or exit PTZ control mode.
USB port
(2x)
Connect a USB flash drive for video backup to one USB port; connect a USB mouse to the
other.
Note:
do not connect two USB flash drives or USB mice at the same time.
rear panel
LAN port
Connect the DVR to a local network by plugging a network cable into this port.
VGA
connector for video monitor (not included)
AUDIO IN
4 audio input channels to connect four external audio sources e.g. from cameras with
audio.
AUDIO OUT
1 audio output to connect to an audio device, e.g. a speaker (mono).
VIDEO IN
4 video input channels to connect 4 external video sources e.g. cameras.
MONITOR
1 video output channel to connect the DVR to the main monitor.
EXTERNAL I/O
use a 9 pin DSUB connector to connect external signals e.g. alarm, PTZ…
power switch
19V DC
Power supply input
6.
Hardware setup
Refer to the illustrations on page
2
of this manual.
Connecting a video monitor
Obtain a suitable monitor (not included) and connect it to the BNC or VGA video output port on the back of
the DVR.
Connecting the power supply
1.
Plug the DC output connector of the included power adaptor into the 19VDC power input at the back of
the DVR.
WARNING:
only use the included adaptor.
2.
Plug the included power cable into the adaptor input connector and plug the other end into the mains.
Do not
switch the DVR on yet.
Connecting a camera
1.
You can connect up to four suitable cameras (included). Each camera needs its own power supply.
2.
Connect the video output of the camera to either video input at the back of the DVR. The number next to
the input connectors represents the channel number. Connector type is BNC (cables included)
Connecting audio
1.
The DVR supports four audio inputs. Connect the audio output of an audio source to an audio input of the
DVR. Make sure to connect the audio channel to the corresponding video channel. Connector type is BNC.
2.
There is also an audio output connector. Connect an audio device e.g. a speaker to this connector when
desired. Connector type is BNC.
Connecting Local Area Network (LAN)
Connect the DVR to a local network by plugging a network cable into the LAN port at the back of the DVR.
Connector type is 8P8C (RJ45). To setup the network connection, press the Menu button and select
. Refer
to the full manual on the included cd for details.
