CARSFM2
Rev. 02
23/12/2010
6 ©
Velleman nv
Note:
this feature only works when supported by the car radio!
Briefly press the MENU/REPEAT button 5 times. Use the
or
button to
select sync mode.
Music input
•
There are 3 ways to provide music files to the transmitter (see §7: file
organization):
1.
using an SD-card. Slide the SD-card in the SD-card slot
[C]
(pins facing
down).
2.
via a USB device. Connect the USB device to the USB connector
[D]
.
3.
through the 2.5mm mini jack. Plug the 2.5mm plug into the mini jack
[E]
.
•
Press and hold the MEM/SD-USB button for ±2s to switch between SD and
USB input.
Playback
•
Set the volume on the transmitter to an average level. Press the
MENU/REPEAT button twice followed by the
or
buttons (7 levels). Use
the volume control on the radio to get the best signal quality.
•
Press the button, to toggle between pause and play mode. In play mode,
press the
or
buttons
to skip to previous or next track. Press and hold
or
for ±2s to skip to previous or next folder (see §7: file organization).
•
In playback mode, press and hold the
button for ±2s to switch the
transmitter display between frequency or remaining play time.
•
In playback mode, pressing and holding the MENU/REPEAT button for ±2s will
scroll through playback modes:
1x Shuffle
mode
2x Repeat
current
track
3x Repeat
current
directory
4x
Normal playback mode
•
7 frequencies can be stored for quick access. First select the desired
frequency, than press the MEM/SD-USB button. Use the
or
buttons to
select a memory address (1~7).
•
To recall a stored frequency, press the MEM/SD-USB button repeatedly until
the desired frequencies is shown on the display.
RDS
•
For music tracks that are provided through the USB-port and that contain an
ID3-tag, a car radio with RDS (Radio Data System) functionality will show the
track information on its display.
•
Briefly press the MENU/REPEAT button 3 times. Use the
or
button to
select the RDS display method and press the MENU/REPEAT button again.
NOR: display shows 8 characters
SCR: display scrolls with 1s interval
•
Briefly press the MENU/REPEAT button 4 times. Use the
or
button to
select the interval time under normal RDS display mode (2~6s) and press the
MENU/REPEAT button again.
Remote control
•
Refer to the overview under §5 for key functions.
•
Use the fast reverse (
) or fast forward (
) buttons to scroll back or forward
through the current track at increased speed (2x, 5x or 10x).
•
To recall a stored frequency, press the FREQ HOTKEY button repeatedly until
the desired frequencies is shown on the display.
•
To repeat only a certain section of a track, press the A
button at the desired
starting point and press the
B button at the desired end point. The section
between A en B will be repeated until the
B button is pressed again.
