CARSFM2
Rev. 02
23/12/2010
5 ©
Velleman nv
remote control
switch between SD and USB
SEARCH
start auto search function
SHUFFLE
Select shuffle - repeat current track – repeat current directory -
normal mode
move to previous or next folder
volume up or down
skip to previous or next track
play or pause
fast reverse or fast forward, speed x2, x5 or x10
move to previous or next frequency
jump to stored frequency
set a bookmark
A
B
set boundaries for repeat section
6.
Installation and operation
Refer to §5 for display indications.
Power
•
Start the cars’ engine and plug the car plug
[A]
into the
12VDC
car cigar
lighter socket.
Starting the car with the transmitter plugged in might
blow the fuse.
•
The transmitter starts automatically. If not, verify the condition of the fuse
inside the plug
[A]
(see §8).
Manually switch power on or off by pressing and holding the
POWER
button
for ±2s.
Note:
when no audio signal is detected for 1 hour, power is switched off.
Set frequency
•
Auto-search
: Switch on the car radio and press the
SEARCH
button to
automatically get the best quality frequency.
After auto-search is completed, the transmitter waits a certain time to allow
the user to set the same frequency on the radio. To change this time-out,
press the MENU/REPEAT button briefly 6 times and use the
or
button to
set it between 2 and 6seconds.
•
Manual search
: Switch on the car radio and search for a free frequency on
the FM-band. Set the same frequency on the transmitter by pressing the
MENU/REPEAT button once followed by the
or
button. Press the
MENU/REPEAT button again to store the setting.
•
Set the same frequency on the car radio, either manual or via the RDS auto
synchronization function. This function enables automatic synchronization of
the radio frequency with the transmitters’ frequency after the auto search
function.
