AVMOD9 & 10 GB
3
c) Connect one end of the supplied adapter with the wall outlet and connect the other end with the jack at the back of the
receiver. Put the power switch in the ON position. The LED on the receiver's front panel lights up.
d) Place the receiver in a suitable location and aim the antenna in such a way that the concave front is facing the camera
(see “Orienting Devices” below).
6. Installing Other Applications
a) Reception on a Computer
•
The yellow plug of the A/V cable is connected with the video jack of the TV tuner or the video capture card of the
computer on the one hand and with the video jack of the receiver on the other hand.
•
Connect the mini stereo plug of the adapter (available in most electronics shops) with the AUDIO IN jack at the back of
the computer and the red and white A/V plugs with, respectively, the AUDIO LEFT and AUDIO RIGHT jacks of the
receiver.
b) Night Vision (ONLY FOR AVMOD9)
•
The
AVMOD9
is equipped with 8 IR LEDs capable of picking up clear images in low-light conditions. Put the
OFF/ON/NIGHT switch at the back of the device in the NIGHT position to engage the night vision function. Deactivate
the night vision function when you don't need it as this saves electricity.
7. Orienting Devices
Place the camera and the receiver on a flat and stable surface. Place the devices as high off the ground as possible so the
operation of the devices will not be impeded by people walking between the camera and the receiver.
Microwave ovens can cause interference. Make sure there is no microwave oven between the camera and the receiver.
Make sure the convex side of the A/V antennas of camera and receiver are facing each other. There is no need to raise the
antennas if camera and receiver are less than 3m apart.
Remark : The A/V antennas were designed to be able to rotate but their rotation range is still limited. The antenna and the
stopper will both be damaged irreparably if you try to rotate the antennas too far.
8. Auto Sequence Function for Monitoring Multiple Locations
The built-in auto sequence function of the receiver is ideal for security purposes. You can purchase additional wireless
cameras with built-in transmitters that transmit picture and audio to the receiver. The receiver is equipped with 4 channels
and uses up to 4 cameras. It displays the picture of these 4 cameras sequentially on 1 single TV/monitor. Thanks to the DIP
switches you can choose several receiver settings. In the default setting only the first DIP switch is in the ON position.
DIP switches 1 through 4 set the auto sequence function of the channels. Place the switch of the channel you want to
display in the ON position. Switch 5 sets the time in between sequences : ON switches channels every 8 seconds, OFF
switches every 4 seconds.
