VELIT R2000, Инструкция по эксплуатации

Страница: 4 / 6

4 | Page
3. INSTALLATION
INSTRUCTIONS
3.1 Choosing Proper Location for the Air
Conditioner
Make sure the roof is designed to support the
weight of the unit and the weight of two installers.
Electrical shock hazard! Make sure to disconnect all
power supplies to the vehicle including battery,
generator, and shore power prior to installation.
● The unit can fit over an existing 14-1/4 by
14-1/4 roof opening. For other locations, make
sure the slope of the select location is less than 15
degrees and leave a clearance of at least 10” from
the edge of the roof. Refer to specifications for the
dimension of the unit.
● After the location has been selected, check for
obstructions in the area where the unit will be
installed.
● Check the inside of the camper for decor panel
obstructions. Allow 6” clearance from all edges of
the opening.
● Route the 6AWG power cable to the roof
opening. Leave at least six inches of slack. For
cables longer than 10ft, refer to NEC (National
Electric Code) for proper sizing of wire (12V 60A).
4.2 Attach the Sealing gasket to the Roof
Opening
● Clean the surface between the unit and the
roof where the sealing gasket will be installed.
● Apply sealant to the bottom of the sealing
gasket.
● Place the sealing gasket on the roof opening.
● For better sealing, apply sealant to the edge
where the sealing gasket contacts the roof.
● At the shown locations and other places if
needed, stick the foam pieces between the unit
and the roof to better support the unit
4.3 Place the Unit in the Roof Opening
● Grasp the bottom two sides of the unit, lift it,
and place it into the roof opening.
● Pull out the power cable.
4.4 Secure the Unit to the Mounting
Brackets
● Choose the proper length of M8 tie rods based
on roof thickness.
● Insert the tie rods in the shown mounting
holes (#10).
● Secure the tie rods with nuts.