1 2
2.0.2. ASSEMBLY AND REPLACEMENT OF SPRINGS
The first time the gait trainer is assembled, the supplied springs
must be fitted. Unscrew the Allen screws in the telescopic tube
(Allen key is located in the rear stop). Remove the plug at the
bottom. Attach the springs to the plugs, push the plugs into the
telescopic tube and refit the screws.
2.0. USER MANUAL
2.0.1. ASSEMBLY OF UPPER PART AND BASE
The upper part is placed in the risers on the chassis. The upper
part is lowered into place in the two risers.
Note:
The handle must face the swivel front wheels.
2.0.3. BRAKE
The brake rods are located in front of the rear wheels. Move
both brake rods backwards to activate the brake function on
both sides. The brakes are deactivated by moving both brake
rods forward again.
Note:
The brake must always be locked
when getting in and out of the gait trainer.
2.0.4. BRAKE ADJUSTMENT
Move the brake rods forward and loosen the two nuts that
attach the brake to the chassis. The brake mechanism can then
be adjusted back and forth. There must be 3-5 mm clearance
between the brake fitting and the cover. Remember to tighten
the nuts again.
Note:
do not adjust the brakes while the gait
trainer is in use.
