V
V
e
e
i
i
l
l
u
u
x
x
V
V
P
P
-
-
3
3
6
6
X
X
U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
Rev.1.0 (Nov. 2010)
15
Website: www.Veilux.net Phone # 1-800-510-6528
100Base-T
100Mbps Ethernet connector (RJ-45). 2 LEDs on the Ethernet connector shows the status of Veilux VP-
36X as the followings:
-
Status LED (Dual Color - Red/Green)
: It will be lit in green or red depending on the status.
Green : Green color indicates that the camera is in normal operation mode. Continuous green
indicates that data transmission is possible. Blinking green means that someone is
connected to Veilux VP-36X.
Red : Continuous or blinking red indicates that hardware is in abnormal condition.
Red/Green LED will be lit with red momentarily and it will be lit with green after a while when
power is applied into Veilux VP-36X
-
LINK/LAN LED (Orange)
It will be lit with orange color when network cabling is all right. Blinking orange color indicates that
normal data transmission is under way. Off state indicates that there is trouble in network connection.
RLY Out (AUX 1, 2)
Relay output is provided for connecting alarm devices or for remote on/off control of devices such as light.
Relay is normal open and it will be closed upon alarm annunciation or remote on. The relay is capable
of switching
30V AC/DC, 2A
. For the application which needs power switching beyond this limit, use
additional relay switch as shown in the right of Figure 2-3.
Figure 2-3. Relay Connection Diagram(Left : Lower than 30V, 2A, Right : Higher than 30V, 2A)
SENSOR IN (Alarm 1,2,3,4)
Connect external alarm sensor. Examples of sensing devices are infrared sensor, motion sensor,
heat/smoke sensor, magnetic sensor, etc.
Connect the two wires of the sensors to “SNS In”. The
