Veigel BLF00006, Инструкция по установке и эксплуатации

Страница: 21 / 36

4-9
Assembly
Button with integrated status LED
Drill a hole with a minimum
19.2 mm diameter in a suitable
place.
Note the length of the button
and plan for a minimum depth of
40 mm.
Insert and screw down the button,
then connect it to the wiring har-
ness supplied.
Fig. 4-12: Assembling the button
ATTENTION!
Make sure that all cables have been laid pinch-free and abrasion-free.
Make sure that the VEA and cables do not collide with the steering system
or the brake and accelerator pedals.
Securely fasten the VEA in the vehicle, then lay and fasten the cables, prefer-
ably with cable ties.
Laying the cables
NOTE
Before finally laying the cables, check that the two contact housings have been
assembled on the accelerator pedals correctly (see Operation on page 4-1). If
they have not, replace the contact housings on the accelerator pedals.