3
2.
START-UP
1.
Turn off the board by disconnecting the power cable.
2.
Manually open the doors halfway.
3.
Depending on the motor type, connect it to
JP13
connector if it has 6 poles, or to
JP10
and
JP11
connectors.
Motor
Phases
JP13
Motor + Encoder
26
27
ENCODER
G
N
D
E
N
C
A
E
N
C
B
+
5
V
25
24
23
22
M1
M2
MOTOR
JP11
JP10
EN
C
O
D
ER
Motor
Phases
JP13
Motor + Encoder
26
27
ENCODER
G
N
D
E
N
C
A
E
N
C
B
+
5
V
25
24
23
22
M1
M2
MOTOR
JP11
JP10
EN
C
O
D
ER
4.
Connect the power cable to the
JP6
connector and check the door closing direction:
a.
If the doors move and complete the closure, go to step 5.
b.
If the doors move in opening:
b1. Change the status of dipswitch 2.
ON
1
2
3
ON
1
2
3
b2. Turn off the board by disconnecting the power supply connector.
b3. Turn on the board again.
NOTE
: the motor direction can ONLY be changed with the dipswitch 2.
The motor direction is acquired ONLY after the board reset.
5.
Make sure that the doors stroke is not interrupted by obstacles and the doors are completely closed.
In case of a Drive with movable coupling cam, check that the cam is closed.
6.
In order to perform the learning of the door stroke, hold the
[LERNING/TEST]
button positioned on the side of
the board for at least 3 seconds, the Drive will slowly open the doors and the integrated keypad will show Ln.
ON
1
2
3
LEARNING/TEST
