7
5.
VEETHREE M2 INSTALLATION
Units are designed to be mounted onto a bulkhead, dashboard, or panel.
The method is described below. The only required components are the
mounting bracket and hardware that are supplied with every Veethree M2
display unit.
Instructions:
•
•
•
•
•
Decide on a location.
Allow adequate clearance behind the display for cable connections. This is
to ensure that the cables are not unduly stressed and for ventilation. Leave
sufficient cable so that the unit may be removed for servicing.
Cut a 2 inch (51 mm) hole.
Screw the studs into rear case.
Place the Veethree M2 display in position, use the mounting bracket and
thumb nuts to secure the unit. The thumb nuts should only be hand tight.
Connect the Deutsch mating part into the housing.
WARNING:
Do not over tighten the studs/thumb nuts and don’t use metal
screws as they may damage the unit and void the warranty.
