Veeder-Root V454501, Техническое руководство

Страница: 5 / 12

1. Upper Display
2. Lower Display
3. Program
4. Preset Output Annunciator
(ON when active)
5. Reset Key
6. Enter
7. Next Key
8. Down
9. Preset
Annunciator
(ON when Preset
value is shown in the
lower display)
NOTE
To abort changes to a
parameter value, press
Down and Next together
instead of
ENT .
IMPORTANT
In Edit Mode, you must
press the
ENT key within
15 seconds of the last
keypress, otherwise the
new data will be lost and
the old data will be
restored.
O P E R A T I O N
Down key
Operator Mode:
Used to change the
currently-selected (flashing) digit.
Depressing this key will decrement the
value (wrap-around from 0 to 9). If the
key is held continuously, the value will
decrement at the rate of 2/sec.
Program Mode:
Used to advance from
one parameter to the next. Once a
parameter value has been selected for
editing (through use of the Next key),
depressing this key will decrement the
value (wrap-around from 0 to 9). If the
key is held continuously, the value will
decrement at the rate of 2/sec.
Configuration Mode:
Used to advance
from one parameter to the next.
Next key
Operator Mode:
Used to select a
parameter for editing (left-most digit will
start to flash) and to move between the
digits. Once the proper digit is selected
(flashing) with the Next key, its value can
be altered through use of the Down key.
Program Mode:
Used to select a
parameter for editing (left-most digit will
start to flash) and to move between the
digits. Once the proper digit is selected
(flashing) with the Next key, its value can
be altered through use of the Down key.
For Decimal Point Position, this key
scrolls through the available choices.
Configuration Mode:
Used to select a
parameter for editing and to scroll through
available choices.
ENT key
Operator Mode/Program Mode:
Confirms an edited value (display will
cease flashing after the
ENT
key is
depressed).
Configuration Mode:
Confirms
setting/value selection (display will cease
flashing after the
ENT
key is depressed).
RST key
Operator Mode/Program Mode:
Resets
count value to either zero or Preset value
(based on the setting of the Count
Direction parameter in Configuration
Mode). Also releases latched outputs.
Configuration Mode:
Exits
Configuration Mode when held down for 2
seconds.
NOTE:
The
RST
key will not be active
unless enabled in Configuration Mode.
For information on Operator Mode, see Page 6.
For information on Program Mode, see Page 7.
For information on Configuration Mode, see Page 8.