Veeder-Root V454501, Техническое руководство

Страница: 6 / 12

Count value
Preset value
The Operator Mode is used for viewing the
Count value and viewing/changing the
Preset value.
Press the Next key to enter Edit Mode.
The most significant digit of the Preset
Data display will then flash. Press the
Next key repeatedly as required to select
the desired digit.
Press the Down key to change the value
of the selected digit (there is wrap-round
from 0 to 9).
When all digits are as required, press the
ENT key to confirm the changes; the
display will stop flashing.
IMPORTANT
You must press the
ENT
key within 15
seconds of the last keypress when entering a
new value, otherwise the new value will be
discarded and the old value will be retained.
NOTE
To abort an edit
operation (before the
new value is confirmed),
press the Down and Next
keys together.
WARNING!
Caution should be
observed if it is
necessary to change
the preset value while
the process is
operating. Do not set
values which are
already exceeded by
the count value without
resetting the counter.
P R O G R A M M I N G