Installation Guide
Wiring the TLS RF
9
TLS RF Installation
Selecting a Location for the TLS RF
WARNING
Explosive vapors or flammable liquids could be present near locations where fuels
are stored or being dispensed. The TLS RF is not explosion proof.
An explosion or fire resulting in serious injury or death, property loss and
equipment damage could occur if the console is installed in a volatile, combustible
or explosive atmosphere (Class I, Division 1 or 2).
Do not install this unit in a volatile, combustible, or explosive atmosphere..
The TLS RF must be mounted indoors, protected from severe vibration, extremes in temperature and humidity,
and other conditions that could harm computerized electronic equipment.
Ensure that the TLS RF is located where neither it nor its associated cabling will be damaged by doors,
furniture, etc. Consider the ease of routing wiring, and ducting to the TLS console. Check that the mounting
surface is strong enough to support the unit’s weight of about 4 pounds.
Mounting the TLS RF
Install the unit’s fastening devices to the mounting surface using the hole pattern (6.7” x 5.7”) shown in Figure
3. Mounting screws up to 3/16” diameter may be used.
Install metal conduit (1/2-inch I.P.S.) between the upper power side knockout on the unit and the power panel.
Figure 3 shows the three designated knockouts (one each on top, left side, and bottom) through which power
wiring can safely enter the unit.
Also install metal conduit (1/2-inch I.P.S.) between the lower intrinsically-safe wiring knockout on the TLS RF
and an intrinsically-safe wiring knockout on the TLS console for device data wiring.
