Vectronics VEC-821K, Руководство пользователя

Страница: 12 / 24

VEC-821K Instruction Manual Super CW Filter Kit
13
Phase 1:
1. Locate resistor R1. This is 1.8K resistor (brown-gray-red).
Carefully bend the leads close to the resistor body to form right-angles
(see following diagram).
.4"
2. Insert R1 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
3. Locate resistor R2. This is 1K resistor (brown-black-red).
Carefully bend the leads close to the resistor body as in Step
#1.
4. Insert R2 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
5. Locate resistor R3. This is 91K resistor (white-brown-orange).
Carefully bend the leads close to the resistor body as in Step
#1.
6. Insert R3 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
7. Locate resistor R4. This is 681K resistor (blue-gray-brown-
orange). Carefully bend the leads close to the resistor body as
in Step #1.
8. Insert R4 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
9. Locate resistor R7. This is 681K resistor (blue-gray-brown-
orange). Carefully bend the leads close to the resistor body as
in Step #1.
10. Insert R7 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
11. Locate resistor R11. This is 681K resistor (blue-gray-brown-
orange). Carefully bend the leads close to the resistor body as
in Step #1.
12. Insert R11 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
13. Locate resistor R18. This is 681K resistor (blue-gray-brown-
orange). Carefully bend the leads close to the resistor body as
in Step #1.
14. Insert R18 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
17. Locate resistor R5. This is 24.3K resistor (red-yellow-orange-
red). Carefully bend the leads close to the resistor body as in
Step #1.