Doc. No.:
Release Transmitter User Manual
Date:
02.07.2019
9
Design is the property of VECTRONIC Aerospace GmbH.
Unauthorized duplication or distribution to a third party is prohibited.
To remove batteries from the compartment, knock the transmitter against your hand
and thus loosen the batteries. Do not insert objects (e.g. screw drivers) into the
compartment to force the batteries out.
Figure 2: Back of Release Transmitter; red arrows indicate the screws for opening the battery
hatch, grey arrow indicates the waterproof seal. Make sure the batteries are inserted with the
correct polarity.
Battery voltage of the release transmitter must not fall under 4.0 Volt. At 4.05 Volt, the
display will warn LowBat. for a few seconds and switch off the backlight. At a lower
voltage, the transmitter cannot be switched on anymore. Please recharge batteries
with the associated Sanyo battery charger only.
The rechargeable Eneloop™ batteries delivered with the transmitter do discharge very
slowly. Do not to exchange them for other batteries, since these might lose voltage
during storage and might not be able to provide enough power to release the collar on
demand. However, if in urgent cases you need to exchange the batteries, and you do
not have an additional set of Eneloop™ batteries, you can use High Power Alkaline
batteries (
Do not recharge these! Danger of explosion!
), NiCd rechargeable batteries,
or NiMH rechargeable batteries with current rating > 1A.