User manual
Vectron
© Höft & Wessel AG
page 43/70
Lin
02.02.2001
1.00
HW90195UserMan.doc
Subject to amendment, errors excepted
6.6 Special features of printer
Paper hold:
After printing the last line the printer holds on tight of the printout for 15 seconds by motor power to facili-
ate the tear off. After this period, resp. if the accu is low, discharged or taken out, the printout needs to be
torn off more carefully. It is also programmable that the radio connection is canceled after the printout.
The printer then turns to sleep mode.
Establish/Cancel the radio connection:
The printer is activated from sleep mode by a RING-signal of the integrated radio module. The printer
awaits the establishing of a connection to the Base Station for the following 30 seconds. If no connection
will be established, the printer turns back to sleep mode. After a succesfully established connection the
printer awaits either print data or the intentional cancellation of the connection by the Base Station. There
is no time-out after the printer has turned to sleep mode.
Infrared-command-mode
The printer turns from sleep mode to infrared-command-mode by pressing the on/off-key. Now the printer
can be configured by the terminal and the IR-interfaces of both devices. The IR-mode will be abandoned
after a time-out of 30 seconds. By pressing the switch on/off-key during IR-mode the printer is switched
off.
fig. 7: simplified mode diagram of mobile printer
Off
Proc. = off
radio module = off
Establish connection
Proc. = on
radio module = on
RING=active
DSR =inactive
DTR=inactive
Sleep
Proz. = sleep
radio module = sleep
RING=inactive
DSR =inactive
DTR=inactive
Ready f. print
Proc. = on
radio module = on
RING=inactive
DSR =active
DTR=active
IR-mode
Proz. = on
radio module = sleep
RING=inactive
DSR =inactive
DTR=inactive
IR-Cmd-mode
Proz. = on
radio module = sleep
RING=inactive
DSR =inactive
DTR=inactive
on/off-key
on/off-key or ti-
meout 30 s
on/off-key
time-out
30s
RING=active
or
DSR=active
DSR=
active
time-out
30s
DSR=
inactiv
DSR=
active
IR-command
end IR-
command
