VECTRIX ZEV OWNER’S MANUAL
5
CharGe leVel
Look at the charge level on the right LCD module.
If there are less than four (4) bars showing, we
suggest you recharge before use.
STanDS Up
Make sure both the side stand and center stand (if
applicable) are up (retracted).
liGhTS anD inDiCaTOrS
When you turn the key to “System On,” you will
notice that the entire instrument panel illuminates.
After a few moments all malfunction light telltales
should go off. If they do not go off, have your Vectrix
checked at a dealer. Replace the headlight bulb if it
has burned out before riding.
TireS
Always check both tires for punctures, tears, or worn
tread. Never ride on balding or bald tires. Maintain
tire pressure at 33 psi (2.2 bar) for the front tire and
40 psi (2.8 bar) for the rear tire.
BraKe flUiD leVelS
Refer to the section on brake fluid level. Make sure
that you have the required amount of fluid before
starting the Vectrix.
Interlocks
CUT-Off SWiTCh
The cut-off switch needs to be in the “on” (run)
position.
SiDe STanD SWiTCh
Make sure the side stand is in the upright position.
CenTer STanD (OpTiOnal)
Make sure the center stand is in the upright
position.
“reaDY” inDiCaTiOn
When you turn your key to the “System On” position,
you will see the “Ready” icon in the left Liquid Crystal
Display (LCD), provided all of the interlocks are
satisfied. The “Ready” icon means that the system
is ready to be enabled.
PrE-ridE chEcks
Warning!
For safety reasons it is extremely important that
you read and understand this section. Failure to
perform these pre-ride checks could result in
serious injury or death.
BraKe leVer enaBle SeQUenCe
Once the “Ready” icon is steady ON, you can begin
the motor enable sequence. First, apply and hold
the left brake, then apply the right brake. “GO” will
appear on the left LCD. The Vectrix is now ready to
drive.
CaBleS anD harneSSeS
Can only be exchanged by technically trained
authorized service agent and are not subject for
exchange in the field.