Vecom ECS-8000, Руководство пользователя

Страница: 57 / 101

50
GETTING TO KNOW YOUR ECS-8000 ©Vecow ECS-8000 User Manual
2.5 Main Board Jumper Settings
2.5.1 Front View of ECS-8000 Main Board with Jumper Location
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To “close” a jumper, you connect the pins
with the clip. To “open” a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
The figure below is the top view of the ECS-8000 main board which is the
main board used in the ECS-8000 Series system. It shows the location of the
jumpers.
JP1
JP4
JP5
JP3
SW1
SW3
SW5
SW6
SW2
SW4
JP2