In rare cases, your multimedia system may not function the way you expect it to. Before calling
the service department, please read the operating instructions thoroughly and go through the
following check list; it may be possible to quickly remedy an apparent malfunction.
Symptoms
Possible cause/remedy
General
The unit does not function. No reaction when the
ignition is turned on and the
POWER
button is
pressed.
•
Check the fuses (unit and vehicle) and the connections (see installation
instructions).
•
Press the RESET button on the TFT monitor.
The unit does not react to pressing buttons on the
remote control.
Remote control batteries empty.
•
Replace batteries with a new cell of type CR2025.
No/low volume during playback.
Audio connections defective.
•
See pin setting in the installation instructions.
Volume set too low.
MUTE input connected incorrectly.
Loudspeaker damaged.
Unit switches with hands-free unit/Telephone is not
being detected even though it has been connected
to the unit.
TEL. MUTE lead connected incorrectly or hands-free unit has an incompatible MUTE
signal (active high).
•
See pin setting in the installation instructions.
Preset contents are lost when the unit is switched
off.
Incorrect power supply connection (permanent positive).
•
See pin setting in the installation instructions.
No Bluetooth function.
Activate the “Bluetooth” option in the setup menu under “System settings”.
TFT monitor
The monitor does not open automatically when
switched on.
The option “TFT Auto Open” in the setup menu is set to “OFF”.
The monitor remains in the incorrect position.
The swivel range of the monitor is blocked by an obstacle.
No picture; only a warning message is displayed
even though the vehicle is stationary.
Hand brake not applied or hand brake signal not connected correctly.
•
See pin setting in the installation instructions.
Picture interference or flickering.
The selected AV source or disc is not compatible with the selected TV standard
(NTSC/PAL).
•
See “Setup menu”, option “System settings”.
AV source connected incorrectly.
•
See pin setting in the installation instructions.
Radio
Poor radio reception.
•
Check if the antenna is completely extended and correctly connected.
•
Check whether the supply voltage’s negative pole is correctly connected to earth
(vehicle chassis).
If the unit is being installed in VW and Audi vehicles, you will need a feed
multicoupler for the antenna.
•
Use a suitable adapter (e.g. Votex).
DVD/CD player
Interference to picture or sound during disc
playback. Picture freezes during playback.
The player cannot play the disc. The disc may be damaged or soiled.
Player does not play the inserted disc.
The format of the inserted disc does not comply with the player’s specifications.
In cold weather conditions, condensation may occur on the laser.
•
Wait approximately 5 minutes until the condensation evaporates.
Playback stops, error message on the monitor.
An integrated safety circuit prevents the temperature in the device from exceeding a
certain value
•
Allow the device to cool down.
Disc cannot be inserted.
There is already a disc inserted in the player.
If you cannot find a solution to your problem, contact an authorised VDO Dayton service
agent or call our Customer Helpdesk*. You will find the telephone number for your country
on the Internet at www.vdodayton.com.
* Telephone support is subject to a fee in some cases.
English
Troubleshooting
29
Содержание MS 6200
Страница 2: ...A 12V A2 A4 A6 A8 A7 RR FR FL RL B ...
Страница 35: ......
Страница 36: ...www vdodayton com 12 2006 Siemens VDO Trading GmbH VRM 6200 ...