Audio/video output “OUTPUT”
☞
Connect the yellow Cinch/RCA plug to a suitable multimedia unit video input.
☞
Connect the white and red Cinch/RCA plugs to the left and right Line or AUX inputs of an
available audio system.
Installing the DVD multimedia system
A
Only trained specialists may install the system.
A
Observe the automotive industry quality standards.
A
Fire hazard. During drilling, be careful not to damage hidden cable harnesses, the fuel tank
and fuel lines.
A
Never drill into supporting or safety-relevant chassis parts.
A
Do not drill through the vehicle roof!
A
The system must be installed such that it cannot become detached during emergency
braking!
■
Note before installing, Fig. 3
❏
The unit must be installed suspended horizontally (overhead). Deviations of -10° to +30°
are permitted. Larger deviations may result in malfunctions.
❏
A rigid connection to the vehicle body is a prerequisite for correct functioning of the DVD
Player.
Determining the installation location, Figs. 4 - 5
The DVD multimedia system is attached via a mounting plate. Depending on the installation
conditions, the mounting plate can be brought into the relevant installation location by
means of the 12 slots and screwed on. The multimedia system can then be attached to the
mounting plate via five M4 screws.
Depending on the thickness of the headliner, either the M4 x 10 mm or the M4 x 15 mm
screws must be used. Check the screw length required prior to final installation.
1. Carefully lever the two transparent covers for the interior lighting off the unit from the
outside using a screwdriver. This enables access to the two front screw attachment points
(Fig. 4).
2. Open the display to access the three rear screw attachment points.
3. Hold the unit at the intended mounting position and make five marks through the screw
attachment holes (Fig. 5).
4. Align the mounting plate with the marks made previously at the installation location and
draw suitable drill hole marks through the slots.
Attaching the unit, Fig. 6
1. Drill the previously marked holes.
2. Screw the mounting plate into position using the self-tapping screws (4 x 10 mm) provided.
3. Connect all the required leads to the unit.
4. Screw the unit to the mounting plate using the five screws (M4) provided.
5. Block up the three rear screw holes with the rubber stoppers provided.
6. Snap the two interior lighting covers back into position.
INSTALLATION INSTRUCTIONS
11
English
Содержание DOM 6500
Страница 3: ...3 ...
Страница 31: ...09 2004 ri DOM 6500 IFU www vdodayton com ...