VDO AcquaLink A2C59501997, Инструкция по эксплуатации

Страница: 32 / 54

Configure and calibrate the fuel level sensor
1. Press to access the main menu and then
scroll and select SENSOR CONFIG .
2. Scroll and select Fuel .
3. Select Tank volume , to set tank capacity.
4. Scroll and select Sensor type , then scroll and
select the sensor type.
5. Scroll and select Calibration , then select the
one or five point calibration procedure ( Do 1
point cal / Do 5 point cal ): calibration
instructions and the ohm value read in real-time
by the sensor
[A] appear.
6. Empty the tank and wait for the read value to
stabilize. Then confirm by pressing the knob.
7. For five point calibration, proceed with all
calibration points by following the on-screen
instructions.
8. Hold down to return to the data pages.
Delete the calibration on the fuel level sensor
1. Press to access the main menu and then scroll and select SENSOR CONFIG .
2. Scroll and select Fuel .
3. Scroll and select Calibration , then select Delete cal : default factory settings are restored.
4. Hold down to return to the data pages.
Configure the other sensors
Following is the procedure to configure the compass and wind, pressure, depth, rudder angle and speed
sensors.
1. Press to access the main menu and then scroll and select SENSOR CONFIG .
2. Scroll and select the type of sensor (e.g. Rudder ).
3. Scroll and select the configuration parameter (e.g. Rudder offset ) and set the value. To view factory
settings, see "Sensor types" on the facing page
NOTICE : confirm all the digits to save the value.
4. Hold down to return to the data pages.
Sensor configuration
32 7” TFT display | Instruction manual v. 1.0 | © 2018 Continental Automotive Switzerland AG