Tach With Display 85mm
Tech Support 1-800-265-1818
http://usa.vdo.com
Instruction Sheet # A2C59519487
Rev
11-2010
Mode Button:
In normal operating situations, Short press of the MODE button
will cycle through;
Total Operating
Hours
Trip Hours
Time
Voltage
Reset the Trip Operating Hours:
1.
Press the Mode key repeatedly until the trip hours are
displayed.
2.
Press and hold Mode key to reset.
Setting the Time:
1.
Press the Mode key repeatedly until the clock is
displayed
2.
Long press the Mode button to enter clock set mode
3.
Short press will increase the value of the flashing
number by 1
4.
Long press to move to the next position
5.
When finished, Long Press to return to clock display
To set clock format (12 / 24 hour) see Set Unit and Alarm
Threshold on page 2.
Note if Pin 1 - Battery (+12 / 24 V) – of the 8 pin
connector is disconnected, the clock will need to be
reset.
Set the Illumination intensity:
1.
Long press the Mode button while the Voltage is
displayed to enter Illumination setting.
2.
Short Presses will increase the value of the flashing
number by 1.
3.
Long press to save the Illumination setting and return to
the Voltage display screen.
