![background image](http://html.mh-extra.com/html/vdo/333-001/333-001_fitting-instruction_858159003.webp)
Set the cylinder selector switch on the rear of the tachometer to the correct setting for your engine (4, 6, or 8
cylinders).
Note:
The red or black wire MUST be removed before adjustment to the cylinder setting, which is made from the
田
ylinder selector
・
switch.
Use a small screwdriver or similar object to reach into the recess. An ink pen works well.
Choose the best mounting position for your particular vehicle. Do not mount the tachometer in a position that
will impair visibility or interfere with driving. Before drilling into the mounting surface. Look for any hidden
wiring or other components that could be damaged by the drill bit as it passes through.
WIRING
Disconnect negative (-) battery cable from your car battery.
Connect
green
wire from back of tachometer to vehicle's tachometer signal source.
CAUTION: You must consult your service manual to ensure the proper connection.
If using an aftermarket ignition system, be sure to follow the manufacturer's instructions.
Connect
black
wire from back of gauge to a good engine ground. Do not assume that any part of the chas-
sis is a good ground.
Use abrasive paper to clean any surface that will be serving as your ground connection.
Connect
red
wire to +12 Volt source that is energized only when the key is on the "on" position. This can be
at the fuse box or the ignition switch "on" position.
Connect
yellow
wire from back of gauge to 12 Volt terminal on ignition switch or other switchable 12 Volt
power source.
Connect
Blue
/
White
wire from back of gauge to Temp sensor
Connect
Orange
wire from back of gauge to Pressure sensor terminal, connect other terminal to negative
Reconnect negative (-) battery cable.
Start engine for 5 to 10 minutes to see temperature change.
After starting engine, check for oil leaks at the pressure sender unit connection point.
Final testing: Push the "Light" button to change the back light to 7 different color, Once a color is selected,
the tachometer will not change colors automatically. To resume this automatic change of colors, press
and hold the light button until it changes to the next color and then release it.
Shift Light Operation
To see the RPM for the shift light: Push the mode button "M" until the "set" green LED light is on, then push ei-
ther the up or down arrow button until the needle moves to the desired RPM. Next, push the mode button "M"
again, the "set" green LED light will go off and the tachometer will return to the standard function.
Installation p/n 333.002
Ignition
Coil
Elect. Ign.
Module
Distributor
Green Signal
Red + 12V Ign.
Black Negative
(Earth)
Yellow Illumi 12V
Blue/White Temp Sender
Orange Pressure sender
8 - 6 - 4 Cyl Setting at rear of Tacho
FA 18 July 2011