VBrick 7000 Series, Руководство по началу работы

Страница: 56 / 78

46 © 2009 VBrick Systems, Inc.
network. VBrick uses the standard Telnet port. See Command Line Interface on page 46 for
an explanation of the commands that are available.
T
To login using Telnet
1. Go to
Start > Run
and type
telnet
to open a Telnet window.
2. Type
open <ip_address>
using the IP address of the VBrick Appliance. This will launch
Command Line Interface.
3. Enter the Login name and Password. Default is
admin
and
admin
.
4. At the VBrick prompt, type
?
to display the top-level commands.
Command Line Interface
The Command Line Interface is a VBrick program used to manage configuration parameters
for the appliance. It provides a subset of commands that you can use if you cannot access
VBAdmin. Regardless of whether you access the CLI through HyperTerminal (shipped with
Windows) or Telnet, the command structure is the same. The CLI interface is launched as
soon as you enter a valid Login name and Password. The following window shows the
Command Line Interface and the "shortcut" commands that are available using the
?
command. You can use these shortcuts at any time during an editing session.
Using the MIB
All VBrick appliance parameters are accessible via an industry-standard SNMP Management
Information Base (MIB). The CLI is a syntactically simple interface which is suitable for
scripting. The syntax for each VBrick parameter is documented in the SNMP MIB for the
appliance.
Note Telnet (as well as FTP, VBAdmin, SNMP, and front panel data) can be disabled on the
VBrick appliance for security purposes. If you cannot login to the appliance via Telnet,
check that the
External Telnet Server
is enabled. Open VBAdmin and go to System
Configuration > Advanced Configurations > Security.